Be sure to unplug the vacuum before disassembling it to prevent electric shock.
  • Be sure to unplug the vacuum before disassembling it to prevent electric shock.

  • Lay vacuum on side.

  • Using a Phillips screwdriver, unscrew the screw behind the front wheels, on the edge of the underside of the vacuum cleaner.

Agregar Comentario

Stand the vacuum upright and identify the dial on the front of the vacuum.
  • Stand the vacuum upright and identify the dial on the front of the vacuum.

  • Unscrew the screw using a Torx 20 screwdriver

  • Pull the dial out.

Agregar Comentario

  • Lift the cover off of the vacuum.

Agregar Comentario

  • Identify the two gray metal plates at the front of the vacuum.

  • Using the T20 Torx screwdriver, remove the four screws on the smaller gray plate holding the larger gray metal plates.

Agregar Comentario

  • Remove the small metal plate with the black bolt in the center.

  • Repeat on opposite side near the other wheel

Agregar Comentario

  • Remove the larger gray metal plate.

  • Repeat on opposite side near other wheel.

Agregar Comentario

  • Remove the front wheels by lifting the silver bar that attaches the two wheels.

  • Detach the spring attaching the wheels to the vacuum.

Agregar Comentario

  • Remove a wheel from the wheel's axel by pulling off the wheel.

  • Slide spring off.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Caycie Pascual

Miembro Desde 26/09/12

1 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 16-58, Forte Fall 2012 Miembro de Cal Poly, Team 16-58, Forte Fall 2012

CPSU-FORTE-F12S16G58

5 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 680