Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
On the back side of the unit, remove the three 8.1mm screws marked with a Phillips #1 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
From the back, lift the case upwards away from the unit then forwards, releasing the prongs on the front.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There is one group of wires located towards the front of the case and attached directly to the motherboard and the case. Using two fingers in a pinching motion, release the wire from the clip and disconnect it.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The disk drive is the large metallic rectangular unit that occupies a third of the space inside the unit.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The disk drive has four 6.5mm screws located near each of its corners that hold it onto the frame. Use a #1 Phillips head screwdriver to remove these screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The disk drive has two connections to the motherboard that can be disconnected by pulling on the blue plastic tabs.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Once the connections are unplugged and the screws are removed, the disk drive can be lifted out. The previous steps can be done in the reverse order to replace the part.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.