Saltar al contenido principal

Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.

Qué necesitas

  1. Este paso está sin traducir. Ayuda a traducirlo

    : paso 1, imagen 1 de 1
    • Flip open the phone, remove the two rubber covers under the LCD screen.

    • Remove the two screws using a small Philips screwdriver.

  2. Este paso está sin traducir. Ayuda a traducirlo

    : paso 2, imagen 1 de 1
    • Using an Ipod opening tool or your finger nails, pry open the back cover of the LCD screen.

    • Note: Some force may be required.

  3. Este paso está sin traducir. Ayuda a traducirlo

    : paso 3, imagen 1 de 1
    • Completely separate the back cover from the rest of the phone.

    • Close the phone.

  4. Este paso está sin traducir. Ayuda a traducirlo

    : paso 4, imagen 1 de 1
    • The speaker is covered with silver tape on the bottom of the logic board.

  5. Este paso está sin traducir. Ayuda a traducirlo

    : paso 5, imagen 1 de 1
    • Remove the silver tape that is covering the speaker.

  6. Este paso está sin traducir. Ayuda a traducirlo

    : paso 6, imagen 1 de 1
    • Remove the speaker.

    • Note: In order to completely remove the speaker you must disconnect the wires, which will require a soldering iron to reattach the new speaker.

  7. Este paso está sin traducir. Ayuda a traducirlo

    : paso 7, imagen 1 de 1
    • Attach the new speaker using a soldering iron.

    • Put the speaker back to it's original position and place the silver tape over it.

Linea de Meta

Una persona más ha completado esta guía.

Equipo

Cal Poly, Team 18-100, Johann Spring 2010 Miembro de Cal Poly, Team 18-100, Johann Spring 2010

CPSU-JOHANN-S10S18G100

4 Miembros

10 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 6

Ultimos 30 días: 13

Todo El Tiempo: 2,336