Partes

No se requieren partes.

Use thumb nail to release the white hook; then use fingertip to pry the battery loose starting from the top.
  • Use thumb nail to release the white hook; then use fingertip to pry the battery loose starting from the top.

  • Second photo gives a view from the back of the phone and battery.

Agregar Comentario

Remove the 4 (4.7mm) philips head screws.
  • Remove the 4 (4.7mm) philips head screws.

Agregar Comentario

  • Unplug the rubber charger outlet cover.

Agregar Comentario

  • Unplug the rubber headset jack cover.

Agregar Comentario

  • Begin by inserting the pry tool near the charger jack.

  • There are 4 tabs to release.

    • Start at the bottom and slide the tool up, lifting the silver front of the phone away from the white backing.

  • Loosen the 2 side tabs before moving on to the top two.

  • See the second photo to see location of the tabs.

  • Be careful of the ribbon wires shown in second photo.

Agregar Comentario

  • Once the two side tabs are free; gently pry the white backing down to release the top two tabs.

  • Hold the phone with the left hand as shown

  • Wiggle the white backplate from side to side while pulling down with the right hand.

  • Be careful of the ribbon wires shown in second photo.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Matthew Hove

Miembro Desde 05/01/11

1,031 Reputación

20 Guías creadas

Equipo

Cal Poly, Team 3-40, Regan Winter 2011 Miembro de Cal Poly, Team 3-40, Regan Winter 2011

CPSU-REGAN-W11S3G40

4 Miembros

20 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,186