Introducción

The Keypad may get worn or dirty as time goes by. This guide will aid in the removal of the keypad for cleaning or replacement.

  1. Slide the latch on the back of the phone up.
    • Slide the latch on the back of the phone up.

    Agregar Comentario

  2. Remove the battery.
    • Remove the battery.

    Agregar Comentario

    • After removing the battery, remove the four small Phillips-head screws with a #0 Phillips screwdriver.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Using a thumbtack, pry the small plastic cover from the case near the base of the antenna.

    Agregar Comentario

    • With a #0 Phillips screwdriver remove the screw which you just uncovered.

    Agregar Comentario

    • Using the spudger, carefully pry the case apart starting near the charging port. Ease the case open.

    • Then disconnect the small power connector near the top of the phone.

    Agregar Comentario

    • Gently pry up the ribbon-type connector with the spudger.

    Agregar Comentario

    • Carefully pry the logic board from the case with the spudger.

    Agregar Comentario

    • Once the logic board has been removed, peel the keypad up.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Nathan Brink

Miembro Desde 11/04/10

1 Reputación

7 Guías creadas

Equipo

Cal Poly, Team 34-59, Forte Spring 2010 Miembro de Cal Poly, Team 34-59, Forte Spring 2010

CPSU-FORTE-S10S34G59

4 Miembros

14 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,485