Partes

No se requieren partes.

Turn Samsung SCH3500 around so that the back is facing you. Depress locking tab on the back of the phone with a finger or thumb. Turn Samsung SCH3500 around so that the back is facing you. Depress locking tab on the back of the phone with a finger or thumb.
  • Turn Samsung SCH3500 around so that the back is facing you. Depress locking tab on the back of the phone with a finger or thumb.

Agregar Comentario

Slide battery toward bottom of the phone, ~1/4 inch, to clear the hooks that keep it secured to the back of the phone.
  • Slide battery toward bottom of the phone, ~1/4 inch, to clear the hooks that keep it secured to the back of the phone.

Agregar Comentario

Lift battery away from phone case.
  • Lift battery away from phone case.

  • The battery is now removed from the device. Congratulations.

Agregar Comentario

Grasp antenna firmly and rotate counterclockwise to unscrew it from the phone. Grasp antenna firmly and rotate counterclockwise to unscrew it from the phone.
  • Grasp antenna firmly and rotate counterclockwise to unscrew it from the phone.

Agregar Comentario

When unscrewed, pull the antenna straight up and out.
  • When unscrewed, pull the antenna straight up and out.

Agregar Comentario

Pull guide tube free from its retaining ring and slide it out the top, like the antenna (optional). The antenna and its guide tube are now removed from the phone. Congratulations.
  • Pull guide tube free from its retaining ring and slide it out the top, like the antenna (optional).

  • The antenna and its guide tube are now removed from the phone. Congratulations.

Agregar Comentario

Remove the four screws using a T6 Torx screwdriver.
  • Remove the four screws using a T6 Torx screwdriver.

Agregar Comentario

Work from the bottom of the phone, separating the two halves of the case. Note: Take care to keep the logic board with the front case half. Part of the logic board is exposed to the sticker under the battery on the rear case half.
  • Work from the bottom of the phone, separating the two halves of the case.

  • Note: Take care to keep the logic board with the front case half. Part of the logic board is exposed to the sticker under the battery on the rear case half.

Agregar Comentario

Angle the rear case half away from the top of the front case half, pivoting the hooks out of their clasps.
  • Angle the rear case half away from the top of the front case half, pivoting the hooks out of their clasps.

  • Caution: Do not fully separate the halves. There is an antenna ribbon connected to the logic board from the back cover.

Agregar Comentario

Disconnect the antenna ribbon cable from the logic board at the Zero Insertion Force (ZIF) connector. The brown portion of the connector lifts up to release the cable end. The Back Cover is now removed. Congratulations. The Back Cover is now removed. Congratulations.
  • Disconnect the antenna ribbon cable from the logic board at the Zero Insertion Force (ZIF) connector. The brown portion of the connector lifts up to release the cable end.

  • The Back Cover is now removed. Congratulations.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Equipo

Clemson, Team 2-6, Benson Spring 2012 Miembro de Clemson, Team 2-6, Benson Spring 2012

CLEM-BENSON-S12S2G6

2 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 2

Todo El Tiempo: 526