Introducción

This guide will explain how to successfully remove the screen underneath the outside shell and on top of the circuit board.

Partes

No se requieren partes.

  1. Remove 4 screws from bottom of camera Remove 2 screws from side of camera Remove 2 screws from side of camera
    • Remove 4 screws from bottom of camera

    • Remove 2 screws from side of camera

    • Remove 2 screws from side of camera

      • Place Screws on magnetic surface or location where they will not roll away

  2. Squeeze area noted by blue square and pull outside shell apart from remaining camera.
    • Squeeze area noted by blue square and pull outside shell apart from remaining camera.

  3. ¡Envío gratuito para todos los pedidos de más de USD100.00 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda

    ¿Alguna vez arreglaste algo? Eso es genial.

    Comparte tu historia de reparación con #SoyUnGenio

    Todos somos Genios

    Comparte tu historia de reparación con #SoyUnGenio

  4. Remove two screws holding screen to circuit board marked by red circles
    • Remove two screws holding screen to circuit board marked by red circles

  5. Lift screen up such that orange circuit ribbon fully extends Flip white peg up noted by blue box Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear.
    • Lift screen up such that orange circuit ribbon fully extends

    • Flip white peg up noted by blue box

    • Using tweezers gently remove orange circuit ribbon from white peg. Make sure white peg remains up otherwise ribbon may tear.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 6

Todo El Tiempo: 329