Introducción

This guide shows how to replace the LCD screen on the Samsung L100.

  1. Remove the six external screws from the camera using a Phillips #0 screwdriver.
    • Remove the six external screws from the camera using a Phillips #0 screwdriver.

    • After the screws has been removed, the bottom of the back half of the external case should be loosened from the camera.

    • Be careful, make sure you don't lose the screws.

    Agregar Comentario

  2. Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.
    • Open the battery cover that's located on the bottom right side of the camera and carefully remove the battery.

    Agregar Comentario

    • Slide your fingernail or a plastic spudger in the groove from the bottom to the top right side of the camera.

    Agregar Comentario

    • Carefully squeeze the top right corner of the camera and pry off the external cover.

    • If you hear a "cracking" sound. This is normal.

    • Continue to pull the external cover and it will come off cleanly.

    • Be cautious of the flash capacitor. It carries an electrical charge, that may give you an unpleasant shock.

    Agregar Comentario

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Carefully pull off the back cover, parts behind the back of the case might fall out.

    Agregar Comentario

    • Remove the screws holding the circuit board.

    • Carefully remove the circuit board.

    Agregar Comentario

    • Carefully lift circuit board from camera.

    • Circuit board still attached to camera by ribbon.

    Agregar Comentario

    • Remove the front cover. It should come off easily.

    • Buttons might fall out when you remove the front cover.

    Agregar Comentario

    • Remove the green tape that holds the LCD screen.

    • Carefully lift the LCD Screen.

    Agregar Comentario

    • Flip the camera over to the other side.

    • Lift the black strip and the ribbon should easily come out.

    • The LCD Screen should be completely separated from the camera now.

    Agregar Comentario

    • Insert the new LCD Screen by pushing the ribbon into the slot.

    • Flip the black strip back down to lock the ribbon in.

    • Your new LCD Screen should be connected to the camera now.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Hasit

Miembro Desde 15/04/10

183 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 6-17, Maness Spring 2010 Miembro de Cal Poly, Team 6-17, Maness Spring 2010

CPSU-MANESS-S10S6G17

4 Miembros

5 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 5,705