Partes

No se requieren partes.

Apply pressure to the back cover and slide it forward towards the camera.
  • Apply pressure to the back cover and slide it forward towards the camera.

  • Lift the back cover off the phone.

Agregar Comentario

Holding the phone firmly, use the notches to grip and lift up the battery.
  • Holding the phone firmly, use the notches to grip and lift up the battery.

Agregar Comentario

  • Remove the four 4.45mm screws at the corners of the phone.

Agregar Comentario

  • Use the plastic opening tool to unhinge the locks around the edges of the phone.

  • Do not worry about the inner components of the phone; they are not connected to this case.

Agregar Comentario

  • Lift the casing off of the phone.

Agregar Comentario

  • With the screws removed, locate the antenna.

Agregar Comentario

  • Using a Phillips head screwdriver, remove the 4.50mm screw holding the antenna in place.

Agregar Comentario

  • Using the plastic opener tool, squeeze gently on the antenna cable connector and lift to remove the connector from its position.

Agregar Comentario

  • Gently lift up on the antenna and remove it from the back of the device.

Agregar Comentario

  • Remove the two 3.50mm screws connecting the motherboard to the case.

Agregar Comentario

  • Use the plastic opener tool to detach the three ribbons on the motherboard.

Agregar Comentario

  • Lift out the top right ribbon from its slot on the motherboard.

Agregar Comentario

  • Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing.

Agregar Comentario

  • Lift the motherboard away from the front casing.

Agregar Comentario

  • After removing lifting up on the motherboard, the front casing and center frame should be separated as shown.

Agregar Comentario

  • Using the plastic opener tool, detach the ribbon located on the bottom of the phone below the battery compartment.

Agregar Comentario

  • Lift the microchip (located at the bottom of the phone) and insert the plastic opener tool under the screen.

  • Lift up the screen. The microchip is attached to the screen and will be lifted out with the screen.

Agregar Comentario

  • After lifting out the LCD screen, the screen and its housing should be separated as shown.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Patrick

Miembro Desde 11/10/11

60 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 3-13, Regan Fall 2011 Miembro de Cal Poly, Team 3-13, Regan Fall 2011

CPSU-REGAN-F11S3G13

4 Miembros

16 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,328