Partes

No se requieren partes.

Apply pressure to the back cover and slide it forward towards the camera.
  • Apply pressure to the back cover and slide it forward towards the camera.

  • Lift the back cover off the phone.

Agregar Comentario

Holding the phone firmly, use the notches to grip and lift up the battery.
  • Holding the phone firmly, use the notches to grip and lift up the battery.

Agregar Comentario

Remove the four 4.45mm screws at the corners of the phone.
  • Remove the four 4.45mm screws at the corners of the phone.

Agregar Comentario

Use the plastic opening tool to unhinge the locks around the edges of the phone. Do not worry about the inner components of the phone; they are not connected to this case.
  • Use the plastic opening tool to unhinge the locks around the edges of the phone.

  • Do not worry about the inner components of the phone; they are not connected to this case.

Agregar Comentario

Lift the casing off of the phone.
  • Lift the casing off of the phone.

Agregar Comentario

With the screws removed, locate the antenna.
  • With the screws removed, locate the antenna.

Agregar Comentario

Using a Phillips head screwdriver, remove the 4.50mm screw holding the antenna in place.
  • Using a Phillips head screwdriver, remove the 4.50mm screw holding the antenna in place.

Agregar Comentario

Using the plastic opener tool, squeeze gently on the antenna cable connector and lift to remove the connector from its position.
  • Using the plastic opener tool, squeeze gently on the antenna cable connector and lift to remove the connector from its position.

Agregar Comentario

Gently lift up on the antenna and remove it from the back of the device.
  • Gently lift up on the antenna and remove it from the back of the device.

Agregar Comentario

Remove the two 3.50mm screws connecting the motherboard to the case.
  • Remove the two 3.50mm screws connecting the motherboard to the case.

Agregar Comentario

Use the plastic opener tool to detach the three ribbons on the motherboard. Use the plastic opener tool to detach the three ribbons on the motherboard. Use the plastic opener tool to detach the three ribbons on the motherboard.
  • Use the plastic opener tool to detach the three ribbons on the motherboard.

Agregar Comentario

Lift out the top right ribbon from its slot on the motherboard.
  • Lift out the top right ribbon from its slot on the motherboard.

Agregar Comentario

Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing. Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing.
  • Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing.

Agregar Comentario

Lift the motherboard away from the front casing.
  • Lift the motherboard away from the front casing.

Agregar Comentario

After removing lifting up on the motherboard, the front casing and center frame should be separated as shown.
  • After removing lifting up on the motherboard, the front casing and center frame should be separated as shown.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Jacob Michener

Miembro Desde 10/10/11

31 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 3-13, Regan Fall 2011 Miembro de Cal Poly, Team 3-13, Regan Fall 2011

CPSU-REGAN-F11S3G13

4 Miembros

16 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 658