Saltar al contenido principal

Introducción

The battery is located inside the camera. To remove the battery, it will require uninstalling the battery housing. This can be done in a few steps found below.

  1. Samsung HMX-W300 Battery  Replacement, Remove wristband: paso 1, imagen 1 de 3 Samsung HMX-W300 Battery  Replacement, Remove wristband: paso 1, imagen 2 de 3 Samsung HMX-W300 Battery  Replacement, Remove wristband: paso 1, imagen 3 de 3
    • To remove the wristband of the device, grab the middle loop and pull the band through (as shown in the picture).

  2. Samsung HMX-W300 Battery  Replacement, Front case screw removal: paso 2, imagen 1 de 2 Samsung HMX-W300 Battery  Replacement, Front case screw removal: paso 2, imagen 2 de 2
    • Remove all four Hex screws with a Hex 1.5 mm screwdriver.

  3. Samsung HMX-W300 Battery  Replacement, Remove HDMI screw: paso 3, imagen 1 de 3 Samsung HMX-W300 Battery  Replacement, Remove HDMI screw: paso 3, imagen 2 de 3 Samsung HMX-W300 Battery  Replacement, Remove HDMI screw: paso 3, imagen 3 de 3
    • To remove the HDMI screw, open the HDMI door on the side. Remove the screw using a size #00 Phillips screwdriver.

  4. Samsung HMX-W300 Battery  Replacement, Open front case.: paso 4, imagen 1 de 3 Samsung HMX-W300 Battery  Replacement, Open front case.: paso 4, imagen 2 de 3 Samsung HMX-W300 Battery  Replacement, Open front case.: paso 4, imagen 3 de 3
    • As shown in the picture, use the iFixit Opening Tool on both sides on the device. Pry apart both sections with light force.

    • Do not apply too much force. There is a wire that attaches the front case with the rear case that can be damaged.

  5. Samsung HMX-W300 Battery  Replacement, Unplug wire.: paso 5, imagen 1 de 3 Samsung HMX-W300 Battery  Replacement, Unplug wire.: paso 5, imagen 2 de 3 Samsung HMX-W300 Battery  Replacement, Unplug wire.: paso 5, imagen 3 de 3
    • Pull the wire ribbon out with a pair of tweezers.

  6. Samsung HMX-W300 Battery  Replacement, Battery screw removal: paso 6, imagen 1 de 2 Samsung HMX-W300 Battery  Replacement, Battery screw removal: paso 6, imagen 2 de 2
    • To remove the battery housing, you must first use a size 00 Phillips screwdriver to remove the four screws.

  7. Samsung HMX-W300 Battery  Replacement, Battery housing removal: paso 7, imagen 1 de 1
    • Use the iFixit Opening Tool to pry the battery housing open.

  8. Samsung HMX-W300 Battery  Replacement, Remove battery: paso 8, imagen 1 de 3 Samsung HMX-W300 Battery  Replacement, Remove battery: paso 8, imagen 2 de 3 Samsung HMX-W300 Battery  Replacement, Remove battery: paso 8, imagen 3 de 3
    • After removing the battery housing, take the battery out.

Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Robert

Miembro Desde 21/01/15

966 Reputación

8 Guías creadas

Equipo

USF Tampa, Team 9-2, Blackwell Winter 2015 Miembro de USF Tampa, Team 9-2, Blackwell Winter 2015

USFT-BLACKWELL-W15S9G2

4 Miembros

16 Guías creadas

2 comentarios

What type of battery is this? What part number should we use to order a replacement?

VanDemark - Contestar

The type of battery should be printed on the case of the battery. Most likely it’s some type of lithium battery. The part number for the battery should be on the case as well. If you can’t find either of these on the battery case you can take the battery to a place that sales batteries and the personnel there should be able to tell you the type and part number for your battery.

Jarretti Reaves -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 12

Todo El Tiempo: 1,914