Introducción

This guide will provide a step by step procedure for installing the camera.

Partes

No se requieren partes.

Using your thumb, press down and slide the back cover away from the  camera.
  • Using your thumb, press down and slide the back cover away from the camera.

Agregar Comentario

Remove the battery from the phone.
  • Remove the battery from the phone.

Agregar Comentario

  • Using a Phillips#00 screw driver, remove the six 4mm screws holding the back case together.

Agregar Comentario

  • Use a plastic opening tool to pry the case off. To do this, find a gap on any side of the phone, top preferably, and slip the tip of the tool in the gap

  • Now use moderate strength and slowly maneuver the tool around the outside until the case becomes loose.

  • Using your fingers, take the case off.

Agregar Comentario

  • The green film above the camera is the camera connector to the motherboard.

  • Use a plastic opening tool to disconnect the camera connector.

Agregar Comentario

  • The golden film connector connects the keyboard to the motherboard.

  • Use a plastic opening tool to disconnect the keyboard connector.

Agregar Comentario

  • The circular connector holds the motherboard in place.

  • Using a plastic opening tool, disconnect the circular connector.

Agregar Comentario

  • There is a LCD connector underneath the motherboard.

  • Gently lift the far edge of the motherboard upwards toward the center of the phone.

  • Using a plastic opening tool, disconnect the LCD connector.

Agregar Comentario

  • After disconnecting the four connectors, gently lift the motherboard up with your fingers.

  • Place the motherboard in a secure area.

Agregar Comentario

  • Use your thumb and index finger to grip the camera connector.

  • Pull the camera connector upwards to detach the camera.

  • The camera was glued on, so this may require moderate strength.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Cameron Law

Miembro Desde 12/10/11

142 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 3-12, Regan Fall 2011 Miembro de Cal Poly, Team 3-12, Regan Fall 2011

CPSU-REGAN-F11S3G12

4 Miembros

14 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 786