Introducción
¿Se ha roto la hebilla de la correa de tu reloj o simplemente quieres sustituir la correa de fábrica por una personalizada? Sólo tienes que cambiarla.
Qué necesitas
-
-
Dale la vuelta al reloj para que la esfera quede hacia abajo.
-
Con un destornillador Y#0, desatornilla los cuatro tornillos de tres cabezas de 3,5 milímetros.
-
-
-
-
Con el dedo, empuja hacia delante el desbloqueo mientras tiras de la correa hacia arriba.
The bracelet should be removed first!
Das Armband sollte zuerst entfernt werden!
-
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
7 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
¡ Carlos López (España - Spain) nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
6 comentarios
can you also provide instruction to change home button on Gear S2
thanks
Where can you buy new straps?
Ebay Amazon etc.
YOU DO NOT NEED TO REMOVE THE SCREWS. Step 1 is completely irrelevant.
The warning to turn off the watch to avoid electrical shock was a joke, right?!
nanev - Contestar
The screws don't seem to be turning easily. What's the best way to loosen them without stripping them?
Mark Franz - Contestar
I’m going to be shocked by a dead 3.8V battery? Of course, only if the watch is powered on. Ridiculous statements like this do not reflect positively on the credibility of this entire procedure. If the author seriously thinks this is a danger then I question your basic understanding of electronics.
Alex Tatistcheff - Contestar
… to avoid being shocked when you lose your data! :)
Reuben Janzen-Martin - Contestar