Saltar al contenido principal

Samsung Galaxy Watch Display Replacement

Qué necesitas

  1. Samsung Galaxy Watch Display Replacement, Opening Procedure: paso 1, imagen 1 de 1
    • Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.

  2. Samsung Galaxy Watch Display Replacement: paso 2, imagen 1 de 2 Samsung Galaxy Watch Display Replacement: paso 2, imagen 2 de 2
    • Use an opening tool to get between the back cover and the metal housing of the watch.

    • Carefully pry the plastic back cover open.

    • Don't remove the back cover yet. There is a flex cable running to the core assembly inside.

  3. Samsung Galaxy Watch Display Replacement: paso 3, imagen 1 de 2 Samsung Galaxy Watch Display Replacement: paso 3, imagen 2 de 2
    • Lay down the watch and lift the back cover to access the sensor connector on the motherboard.

  4. Samsung Galaxy Watch Display Replacement: paso 4, imagen 1 de 2 Samsung Galaxy Watch Display Replacement: paso 4, imagen 2 de 2
    • Use a spudger to disconnect the sensor flex cable from the motherboard.

  5. Samsung Galaxy Watch Display Replacement: paso 5, imagen 1 de 3 Samsung Galaxy Watch Display Replacement: paso 5, imagen 2 de 3 Samsung Galaxy Watch Display Replacement: paso 5, imagen 3 de 3
    • Remove the back cover.

    • When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.

  6. Samsung Galaxy Watch Display Replacement, Core Assembly Removal: paso 6, imagen 1 de 2 Samsung Galaxy Watch Display Replacement, Core Assembly Removal: paso 6, imagen 2 de 2
    • Use a spudger to disconnect the display flex cable from the motherboard.

  7. Samsung Galaxy Watch Display Replacement: paso 7, imagen 1 de 2 Samsung Galaxy Watch Display Replacement: paso 7, imagen 2 de 2
    • Lift the core unit out of the housing.

    • The core's plastic frame sits tight inside the housing.

    • Carefully thread the display flex cable through the gap of the core's plastic frame.

  8. Samsung Galaxy Watch Display Replacement, Display: paso 8, imagen 1 de 1
    • If necessary apply some tape over the display to avoid any injury from glass shards.

  9. Samsung Galaxy Watch Display Replacement: paso 9, imagen 1 de 2 Samsung Galaxy Watch Display Replacement: paso 9, imagen 2 de 2
    • Use your finger or thumb to steadily push down on the display to loosen the adhesive.

    • Heating the display with a hair dryer or iOpener helps softening the adhesive.

    • Remove the display.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

8 personas más completaron esta guía.

Tobias Isakeit

Miembro Desde 03/31/14

116,767 Reputación

188 Guías creadas

Equipo

Master Techs Miembro de Master Techs

Community

322 Miembros

2,506 Guías creadas

Un comentario

Hi does this process work with the galaxy 5 watch?

Rey Thomas Jude Ho - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 45

Ultimos 7 días: 281

Ultimos 30 días: 1,171

Todo El Tiempo: 50,137