Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
To soften the adhesive holding the tablet together, heat up the edges of the glass panel using a heated iOpener on the edge of the device. Alternatively you can use a heat gun to loosen the adhesive.
-
Leave the iOpener on edge for two minutes.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place a suction cup near edge that you heated up with the iOpener.
-
Press down on the suction cup to create a seal, and pull up with force to create a separation between the display and the midframe.
-
Use an opening tool to split apart the glass panel from the midframe.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Plastic Cards$2.99-
As you continue along the edge using the opening tool, use a plastic card to keep the glass separate from the midframe.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull off the glass panel using the suction cup.
-
Carefully disconnect the ribbon cable connecting the display assembly to the motherboard. You can disconnect this ribbon from either end.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Repeat steps 3 through 7 to remove the rear glass panel on the opposite side of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Phillips #000 screwdriver to unscrew the five screws securing the battery, and the twenty-two screws surrounding the midframe.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The midframe should snap off from the device’s motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the ribbon running from the midframe and disconnect it from the motherboard with the flat end of a spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of the spudger to pop off the connector between the battery and the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Flip the midframe over and pop the battery out, making sure to slide it out from underneath the ribbon cables.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The battery should now be removed and detached from the device.
-
Cancelar: No complete esta guía.
9 personas más completaron esta guía.
7 comentarios
This repair can be done without removing the screen!
how? would it be simpler to do it that way?
There is no reason to remove the screen. It’s super risky to do it that way. When you take the battery out, just use some alcohol on the sides of the battery to weaken the adhesive and use a suction cup to pull the battery out. No need to push on it from the screen side.
What I get for reading a guide before checking comment, TOTALLY unnecessary step in removing screen. LCD cost $220 on ebay….
Un vrai tuto de merde avec lequel vous êtes assuré de niquer votre tablette !!! Je vous recommande expressément de rechercher sur youtube “ How to Replace Your Samsung Galaxy Tab S3 SM-T825 Battery “ pour trouver un VRAI TUTO simple et qui vous évitera à coup sur de flinguer votre écran.
P de Rochefort