Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the plastic opening tool into the SD card slot or charge port.
-
Try in an upward motion until you see a separation between the tablet and back cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Work around the entire device by sliding the plastic opening tool around the rim.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the back cover once all links have been separated.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the plastic opening tool in between the outer rim.
-
Move the tool in a downward motion to separate the 2 parts.
-
Run the tool along the rim to disconnect all connectors holding the outer rim to the back of the device.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Repeat this step for all four sides, then remove the rim.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the Phillips #00 screwdriver, remove the two screws holding the headphone jack.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the hook of a spudger on the backside of headphone jack and pop the headphone jack out.
-
Cancelar: No complete esta guía.
2 personas más completaron esta guía.