Saltar al contenido principal

Introducción

This guide will show you how to take off the back panel of the device and take out and replace the battery.

  1. Begin by separating the back panel from the screen glass assembly using the plastic opening tool.
    • Begin by separating the back panel from the screen glass assembly using the plastic opening tool.

    • Insert the plastic opening tool between the edge of the glass screen and the metal frame around the device.

  2. Continue around the entire device until the back panel is completely separated from the screen. Continue around the entire device until the back panel is completely separated from the screen.
    • Continue around the entire device until the back panel is completely separated from the screen.

  3. Remove the four 2.5mm Phillips #000 screws. Remove the four 2.5mm Phillips #000 screws.
    • Remove the four 2.5mm Phillips #000 screws.

  4. Gently pull up on the plastic tab that has red, blue and black wires that connects the battery to the motherboard.
    • Gently pull up on the plastic tab that has red, blue and black wires that connects the battery to the motherboard.

  5. The battery should be completely disconnected and the new one can be installed.
    • The battery should be completely disconnected and the new one can be installed.

Conclusión

To reassemble your device, follow these instructions in reverse order.

14 personas más completaron esta guía.

Equipo

USF Tampa, Team 9-2, Lacy Fall 2016 Miembro de USF Tampa, Team 9-2, Lacy Fall 2016

USFT-LACY-F16S9G2

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 30

Ultimos 30 días: 131

Todo El Tiempo: 8,838