Repara tus cosas Comunidad Tienda

Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement

Introducción

Replacement guide for the power and volume buttons on a Samsung Galaxy Tab 4 10.1 android tablet.

The battery only needs to be disconnected—skip steps 2, 3, 5, and 6.

Qué necesitas

  1. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement, Battery: paso 1, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement, Battery: paso 1, imagen 2 de 2

    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

    Editar

  2. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement: paso 2, imagen 1 de 1

    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

    Editar

  3. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement: paso 3, imagen 1 de 1

    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

    Editar

  5. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement: paso 4, imagen 1 de 1

    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

    Editar

  6. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement: paso 5, imagen 1 de 1

    • Use the nylon spudger to remove the battery by prying up on the edges.

    Editar

  7. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement: paso 6, imagen 1 de 1

    • Once the battery is loose, lift it out of the device.

    Editar

  8. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement, Power and Volume Button: paso 7, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement, Power and Volume Button: paso 7, imagen 2 de 2

    • Pry up and disconnect the power and volume button press-fit connector with the flat end of a spudger.

    Editar

  9. Samsung Galaxy Tab 4 10.1 Power and Volume Button Replacement: paso 8, imagen 1 de 1

    • Remove the power and volume button ribbon cable.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

4 personas más completaron esta guía.

Autor

Blake Klein

Miembro Desde 01/29/17

70,510 Reputación

50 Guías creadas

Insignias: 43

+ 40 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 5

Ultimos 30 días: 22

Todo El Tiempo: 3,635