Saltar al contenido principal

Introducción

Replacement guide for the loudspeakers on a Samsung Galaxy Tab 4 10.1 android tablet.

  1. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement, Battery: paso 1, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement, Battery: paso 1, imagen 2 de 2
    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

  2. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 2, imagen 1 de 1
    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

  3. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 3, imagen 1 de 1
    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

  4. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 4, imagen 1 de 1
    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

  5. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 5, imagen 1 de 1
    • Use the nylon spudger to remove the battery by prying up on the edges.

  6. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 6, imagen 1 de 1
    • Once the battery is loose, lift it out of the device.

  7. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement, Motherboard: paso 7, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement, Motherboard: paso 7, imagen 2 de 2
    • Remove the two 2.7mm Phillips #00 screws from the motherboard.

  8. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 8, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 8, imagen 2 de 2
    • Use the flat end of a spudger to pry up and disconnect the five press-fit connectors from the motherboard.

  9. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 9, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 9, imagen 2 de 2
    • Use a spudger to pry up the motherboard, and remove it from the device.

  10. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement, Loudspeaker: paso 10, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement, Loudspeaker: paso 10, imagen 2 de 2
    • Insert the pointed end of a spudger underneath the ribbon connector of the left loudspeaker.

    • Pry upwards to remove the loudspeaker.

  11. Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 11, imagen 1 de 2 Samsung Galaxy Tab 4 10.1 Loudspeaker Replacement: paso 11, imagen 2 de 2
    • Insert the pointed end of a spudger underneath the headphone jack .

    • Pry upwards to remove the loudspeaker.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Blake Klein

Miembro Desde 29/01/17

65,084 Reputación

55 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 357