Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Prereq to remove the interior midframe and motherboard assembly.

  1. Remove the ten 3.4 mm Phillips #000 screws from the display side of the midframe.
    • Remove the ten 3.4 mm Phillips #000 screws from the display side of the midframe.

  2. Flip the phone over and remove the following screws from the battery side of the midframe:
    • Flip the phone over and remove the following screws from the battery side of the midframe:

    • Two 4.4 mm Phillips #000 screws near the USB port on the battery side of the phone

    • One 4.4 mm Phillips #000 screw

  3. Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips. Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips. Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips.
    • Gently run a plastic opening tool down along the left inner side of the interior frame to separate the three white plastic clips.

  4. The midframe is composed of two halves that encase the motherboard. Gently pull the long sides of the silver bezel out away from the phone to separate the two halves of the midframe.
    • The midframe is composed of two halves that encase the motherboard.

    • Gently pull the long sides of the silver bezel out away from the phone to separate the two halves of the midframe.

    • It may be helpful to gently push in from the inside of the battery compartment, but be careful not to flex the interior half of the midframe, as the motherboard is mounted to it.

  5. Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves. Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves.
    • Continue on to the right side of the silver bezel, pulling away from the interior section of the midframe to separate the two halves.

  6. Use a plastic opening tool to pry any remaining corners out of the silver bezel. Use a plastic opening tool to pry any remaining corners out of the silver bezel.
    • Use a plastic opening tool to pry any remaining corners out of the silver bezel.

  7. Carefully remove the interior midframe/motherboard assembly from the white inner midframe. Carefully remove the interior midframe/motherboard assembly from the white inner midframe.
    • Carefully remove the interior midframe/motherboard assembly from the white inner midframe.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Miembro Desde 18/10/12

418,486 Reputación

547 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

127 Miembros

12,660 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 3

Todo El Tiempo: 340