Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.
Introducción
This guide shows how to remove everything from the display assembly.
Qué necesitas
-
-
Insert a fingernail or plastic opening tool in the gap between the rear case and the base of the phone.
-
-
-
Slide your fingernail or plastic opening tool along the edge of the rear case.
-
Lift the case gently from the base.
-
-
-
Insert a fingernail or plastic opening tool into the small gap between the battery and the phone base.
-
Lift the battery out of its recess.
-
-
-
Place your fingernail in the groove of the stylus pen.
-
Pull the stylus pen away from the phone.
-
-
-
Remove the twelve 4mm Phillips #00 screws from the back chassis.
-
-
-
-
Insert the plastic opening tool into the Stylus Pen placement holder.
-
Lift the plastic opening tool so that the midframe separates from the base.
-
-
-
Use tweezers to remove both antenna clips.
-
Use a spudger to disconnect six cable connectors.
-
-
-
Lift the spudger to separate the jack assembly from the motherboard.
-
Pull to remove.
-
-
-
Remove the metal bracket located in the top left hand corner.
-
-
-
Remove the vibrating motor by pulling up on it carefully with the tweezers.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancelar: No complete esta guía.
146 personas más completaron esta guía.
Equipo
USF Tampa, Team 2-2, Blackwell Fall 2014 Miembro de USF Tampa, Team 2-2, Blackwell Fall 2014
USFT-BLACKWELL-F14S2G2
4 Miembros
25 Guías creadas
