Repara tus cosas Comunidad Tienda

Samsung Epix LCD Display Replacement

Introducción

This guide shows you how to access the LCD display inside your phone.

Qué necesitas

  1. Samsung Epix LCD Display Replacement, Battery: paso 1, imagen 1 de 1

    • Press button on back of phone below camera.

    • While button is depressed, remove the back panel of the phone by it sliding off (not shown in picture).

    Traducir

  2. Samsung Epix LCD Display Replacement: paso 2, imagen 1 de 1

    • Grasp the bottom corners of the battery with two fingers and gently lift.

    Traducir

  3. Samsung Epix LCD Display Replacement, LCD Display: paso 3, imagen 1 de 1

    • Remove the rubber screw cover in the top left corner by prying upwards with an opening tool.

    Traducir

  4. Samsung Epix LCD Display Replacement: paso 4, imagen 1 de 1

    • Use a Phillips #00 screwdriver to remove the six screws on the back of the phone.

    • The upper right screw is 4.5 mm and the others are 6.5 mm.

    Traducir

  6. Samsung Epix LCD Display Replacement: paso 5, imagen 1 de 2 Samsung Epix LCD Display Replacement: paso 5, imagen 2 de 2

    • Slide the opening tool along the seam on the side of the phone and turn it slightly to unhook the eight clips.

    • There are three clips on each side and two at the bottom of the phone.

    Traducir

  7. Samsung Epix LCD Display Replacement: paso 6, imagen 1 de 1

    • Once all eight of the clips have been unhooked, lift the back panel off of the phone.

    • Be careful not to remove the front panel. It will still be connected to the phone chassis by a ribbon cable on the motherboard.

    Traducir

  8. Samsung Epix LCD Display Replacement: paso 7, imagen 1 de 1

    • Using an opening tool, undo the ZIF connector halfway up the right side.

    • Carefully remove ribbon cable.

    Traducir

  9. Samsung Epix LCD Display Replacement: paso 8, imagen 1 de 1

    • Remove the front faceplate by lifting it off of the phone chassis.

    Traducir

  10. Samsung Epix LCD Display Replacement: paso 9, imagen 1 de 1

    • Using the opening tool, unlatch the LCD ribbon cable.

    Traducir

  11. Samsung Epix LCD Display Replacement: paso 10, imagen 1 de 1

    • Using an opening tool or spudger, pry under the lower left and right corners of the LCD screen.

    • The LCD is held in place to the chassis with adhesive strips.

    • Do not pry excessively hard. You may damage the circuitry on the back of the LCD.

    Traducir

  12. Samsung Epix LCD Display Replacement: paso 11, imagen 1 de 1

    • Lift the LCD display out from phone chassis.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 8 otros colaboradores

Mark Wyse

Miembro Desde 04/19/11

59 Reputación

2 Guías creadas

Insignias: 6

+ 3 más insignias

Equipo

Cal Poly, Team 15-15, Regan Spring 2011 Miembro de Cal Poly, Team 15-15, Regan Spring 2011

CPSU-REGAN-S11S15G15

5 Miembros

5 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 2

Ultimos 30 días: 2

Todo El Tiempo: 1,893