Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Samsung Captivate Camera Assembly Replacement

Qué necesitas

  1. Samsung Captivate Camera Assembly Replacement, Battery: paso 1, imagen 1 de 1
    • Remove the back cover by pressing on the bottom section of the phone and sliding the bottom piece downward.

    • Lift up the back cover.

  2. Samsung Captivate Camera Assembly Replacement: paso 2, imagen 1 de 1
    • Place your finger on the bottom of the battery and lift to remove.

  3. Samsung Captivate Camera Assembly Replacement: paso 3, imagen 1 de 1
    • Replace the old battery with the new one.

  4. Samsung Captivate Camera Assembly Replacement, Rear Case: paso 4, imagen 1 de 1
    • Insert the spudger underneath the bottom section of the phone.

    • Gently lift and push the spudger to slide the bottom section down to reveal two hidden screws.

  5. Samsung Captivate Camera Assembly Replacement: paso 5, imagen 1 de 1
    • Remove the six 4.5mm #000 Phillips screws.

  6. Samsung Captivate Camera Assembly Replacement: paso 6, imagen 1 de 3 Samsung Captivate Camera Assembly Replacement: paso 6, imagen 2 de 3 Samsung Captivate Camera Assembly Replacement: paso 6, imagen 3 de 3
    • Starting at a bottom corner, use the spudger to separate the rear case from the front display.

    • Move the spudger towards the top on both sides. The plastic opening tool is easier to use for this step.

    • Be careful when detaching the top. Free each side, stopping short of the center of the cover. Apply backward pressure on both corners with a finger applying pressure on the center, and slide the whole back cover toward the bottom of the device. Note: forcing the cover can result in cracked plastic.

  7. Samsung Captivate Camera Assembly Replacement: paso 7, imagen 1 de 1
    • Separate the rear case from the phone.

  8. Samsung Captivate Camera Assembly Replacement, Camera Assembly: paso 8, imagen 1 de 1
    • Use the spudger tool to pry up the chip labeled "NEC." This releases the chip.

  9. Samsung Captivate Camera Assembly Replacement: paso 9, imagen 1 de 1
    • Gently lift the camera assembly out of the plastic housing.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Drew Bentz

Miembro Desde 09/22/11

565 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 20-25, Maness Fall 2011 Miembro de Cal Poly, Team 20-25, Maness Fall 2011

CPSU-MANESS-F11S20G25

3 Miembros

9 Guías creadas

2 comentarios

Is this for the front facing camera

tracy mann - Contestar

No, this is for the rear facing camera. The Samsung Captivate does not have a front facing camera.

Will Budney -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 3

Todo El Tiempo: 2,321