Introducción

This guide will be showing step-by-step instructions on how to get to and replace the gearbox of the airsoft gun.

  1. Using a flathead screwdriver, remove the pin holding the hand guard in place.
    • Using a flathead screwdriver, remove the pin holding the hand guard in place.

      • To remove this, turn the pin clockwise and push it through at the same time.

    • Remove the hand guard.

    Agregar Comentario

  2. Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun.
    • Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun.

      • There should be four total.

    Agregar Comentario

    • Turn the gun over so that you are facing the bottom of the gun.

      • Using a Phillips #1 screwdriver, remove the following screws:

        • Remove the 8mm screw that is located directly underneath the cocking lever.

        • Remove the 8mm screw located beside the screw you just removed.

    Agregar Comentario

    • Carefully tug on the tip of the gun and pull the barrel and its cover out.

    Agregar Comentario

    • Locate the hand grip.

    • Using a Phillips #0 screwdriver, remove the two 6mm screws at the bottom of the hand grip.

    • Slide the cover off.

    Agregar Comentario

    • Pull the motor out of the hand grip.

    • Using a Phillips #1 screwdriver, remove the two 5mm screws inside of the hand grip.

    Agregar Comentario

    • Locate the pin holding the folding stock in place.

    • Using an allen wrench or something small, carefully push the pin out.

    Agregar Comentario

    • Using a Phillips #1 screwdriver, remove the 20mm screw behind the folding stock and above the gearbox.

    • Remove the cover that was held on by the screw.

    Agregar Comentario

    • Using a flathead screwdriver, remove the two 5mm screws beside the safety switch on both sides of the gun.

    • Slide off the piece that was held on by those screws.

    Agregar Comentario

    • Using a small allen wrench, carefully unscrew the screws holding the safety switch in place on both sides of the gun.

      • The screws do not have to be taken out all the way, just slightly loosen them until you are able to pull the switch off.

    Agregar Comentario

    • Using a Phillips #0 screwdriver, remove the two 6mm screws that were underneath the safety switch on both sides of the gun.

    • Carefully remove the pieces that were held on by the screws.

    Agregar Comentario

    • Pull apart the cover when pulling the gearbox out.

    • Pull the gearbox out.

      • The gears will fall out when taking the gearbox out. Careful not to lose them.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

Amanda Toan

Miembro Desde 05/10/12

283 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 18-41, Regan Fall 2012 Miembro de Cal Poly, Team 18-41, Regan Fall 2012

CPSU-REGAN-F12S18G41

6 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 8

Todo El Tiempo: 1,762