Introducción

This guide will be showing step-by-step instructions on how to get to and replace the barrel of the airsoft gun.

Partes

No se requieren partes.

  1. Using a flathead screwdriver, remove the pin holding the hand guard in place.
    • Using a flathead screwdriver, remove the pin holding the hand guard in place.

      • To remove this, turn the pin clockwise and push it through at the same time.

    • Pull the hand guard off.

    Agregar Comentario

  2. Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.
    • Using a Phillips #1 screwdriver, remove the two 8mm screws above the hand guard on both sides of the gun. There should be four total.

    Agregar Comentario

    • Locate the button to fold over the folding stock and fold over the folding stock.

    • Using a Phillips #1 screwdriver, remove the 20mm screw located behind the folding stock.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Turn the gun over so that you are facing the bottom of the gun.

      • Using a Phillips #1 screwdriver, remove the following screws:

        • Remove the 8mm screw located directly underneath the cocking lever.

        • Remove the 8mm screw beside the one you just removed.

    Agregar Comentario

    • Carefully tug on the tip of the gun and pull the barrel and its cover out.

    Agregar Comentario

    • Pull the barrel out from the cover.

    • Remove the pieces at the end of the barrel.

    Agregar Comentario

    • Remove the remaining pieces of on the ends of the barrel.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Laura Schulz

Miembro Desde 05/10/12

1 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 18-41, Regan Fall 2012 Miembro de Cal Poly, Team 18-41, Regan Fall 2012

CPSU-REGAN-F12S18G41

6 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 2

Últimos 7 Días: 3

Últimos 30 Días: 6

Todo El Tiempo: 1,159