Saltar al contenido principal

Ryobi RJ1861V Assembly Bar Bearing Replacement

Qué necesitas

  1. Ryobi RJ1861V Assembly Bar Bearing Replacement, Saw Bar Assembly: paso 1, imagen 1 de 1
    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

  2. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 2, imagen 1 de 2 Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 2, imagen 2 de 2
    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

  3. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 3, imagen 1 de 1
    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

  4. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 4, imagen 1 de 1
    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

  5. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 5, imagen 1 de 1
    • Remove the backside panel.

  6. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 6, imagen 1 de 1
    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

  7. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 7, imagen 1 de 1
    • Lift the assembly bar up and out of the chassis.

  8. Ryobi RJ1861V Assembly Bar Bearing Replacement, Assembly Bar Bearing: paso 8, imagen 1 de 1
    • Begin with the top of the device facing up.

  9. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 9, imagen 1 de 1
    • Insert needle nose pliers to remove the retaining pin at the top of the bearing.

  10. Ryobi RJ1861V Assembly Bar Bearing Replacement: paso 10, imagen 1 de 1
    • Once the retaining pin has been removed, pull off the damaged bearing and insert a new one.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 14

Todo El Tiempo: 409