Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Detach the battery unit from the drill body by pressing the battery release buttons on both sides of the unit and pulling outwards.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a Torx T10 screw driver to unscrew all ten 13.5 mm screws from the drill casing to gain access to the interior.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently lift the casing from the drill body.
-
Take the casing completely off the drill body to gain access to the interior of the drill.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Grip the battery clip and pull straight up to remove the metal battery contacts.
-
You can now clean the metal battery contacts with isopropyl alcohol.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Holding the direction select switch in place, grip both sides of the trigger assembly and lift it up and towards the base of the drill.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To separate the trigger assembly from the motor, use a soldering iron to melt the solder and pull gently on the red and black wires from the trigger.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.