Ridgid R86034 LED Replacement

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Introducción

The trigger is a multi-speed switch and requires replacing the whole assembly. Soldering is necessary for this guide. Please familiarize yourself with the iFixit guide on Soldering before starting.

Qué necesitas

Paso 1 Disassembling Ridgid R86034 Housing

Ridgid R86034 LED Replacement, Disassembling Ridgid R86034 Housing: paso 1, imagen 1 de 1

Use the flat side of a metal spudger to peel the black rubber cover off of the casing.
Use some force; the rubber cover is securely attached to the housing.
Rotate the casing until it fits onto the housing with no gaps between it and the clear cover.
Orientation is important when putting the rubber cover on the casing.

Traducir

Paso 2

Remove the plastic cover with your hands.
There is no need to force off the plastic cover. The plastic cover should be much easier to remove than the rubber cover.

Traducir

Paso 3

Ridgid R86034 LED Replacement: paso 3, imagen 3 de 3

Unscrew the four 16 mm long screws from the back panel with a T10 Torx Screwdriver.
Use a firm grip to peel off the back panel. It is sealed tight and requires a good amount of force to remove.

Traducir

Paso 4

Unscrew the eight 15 mm T10 Torx screws from the housing
The screw hole located nearest the battery port is deep and small. Most screwdrivers with replaceable bits will not fit into the hole. Instead, use a conventional screwdriver that fits.

Traducir

Paso 5

Place the driver flat on a table before completely separating the two halves of the housing so components of the drill don't fall out during opening.
Pry apart the two halves of the housing at the back side of the driver using the metal spudger.
The housing is easier to remove if you pry from multiple sides.

Traducir

Paso 6

Do not remove the direction switch.
Pull out all electrical components from housing by hand.
Lift out the motor.
Follow the wires.
The components should come out of their respective slots with ease and require little force to lift out.
The circuit board located nearest the battery pack and the LED light will be hard to pull out.
Remember to precisely place all components in their correct slots with their correct orientations when reassembling.

Traducir

Paso 7 LED

Ridgid R86034 LED Replacement, LED: paso 7, imagen 1 de 1

Identify the LED light. Look for the component with clear casing with two wires attached located toward the bottom of the driver.

Traducir

Paso 8

Ridgid R86034 LED Replacement: paso 8, imagen 3 de 3

Cut the pink and white wire attached to the LED as a little more than a quarter inch from the LED.

Traducir

Paso 9

Strip the wires on the LED by a quarter inch.

Traducir

Paso 10

Strip the wires that were connected to the LED on the circuit board about a quarter inch.

Traducir

Paso 11

Solder the new LED with striped wires to the wire attached to the circuit board.
Wrap the newly soldered connection with electrical tape to ensure that the circuit isn't shorted.

Traducir