Saltar al contenido principal

Ricoh YF-20 Super Front Cover Replacement

Qué necesitas

  1. Ricoh YF-20 Super Front Cover Replacement, Front Cover: paso 1, imagen 1 de 2 Ricoh YF-20 Super Front Cover Replacement, Front Cover: paso 1, imagen 2 de 2
    • Unscrew the seven indicated screws from the left, right, bottom, and back sides of the camera.

  2. Ricoh YF-20 Super Front Cover Replacement: paso 2, imagen 1 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 2, imagen 2 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 2, imagen 3 de 3
    • Loosen the back cover from both the left and the right sides of the camera.

    • Remove back cover. The lid of the battery compartment may fall off because it is not attached to anything.

  3. Ricoh YF-20 Super Front Cover Replacement: paso 3, imagen 1 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 3, imagen 2 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 3, imagen 3 de 3
    • Open the film compartment.

    • Press your finger on top of the grey latch on the left side of the camera.

  4. Ricoh YF-20 Super Front Cover Replacement: paso 4, imagen 1 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 4, imagen 2 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 4, imagen 3 de 3
    • Removing the film compartment door is optional. However, it may aid maneuverability in future steps.

    • Use a thin object like a toothpick or a small screwdriver to push down on the metal pin holding the film compartment door in place.

    • Use your fingers to completely remove the metal pin.

    • Remove the film compartment door.

  5. Ricoh YF-20 Super Front Cover Replacement: paso 5, imagen 1 de 2 Ricoh YF-20 Super Front Cover Replacement: paso 5, imagen 2 de 2
    • Using a thin shaft screwdriver, unscrew the two indicated screws within the film compartment.

  6. Ricoh YF-20 Super Front Cover Replacement: paso 6, imagen 1 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 6, imagen 2 de 3 Ricoh YF-20 Super Front Cover Replacement: paso 6, imagen 3 de 3
    • Loosen the front cover from the left and right sides of the camera.

    • Remove the front cover.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Eric Dazet

Miembro Desde 04/10/12

352 Reputación

5 Guías creadas

Equipo

Cal Poly, Team 6-21, Amido Spring 2012 Miembro de Cal Poly, Team 6-21, Amido Spring 2012

CPSU-AMIDO-S12S6G21

4 Miembros

18 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 11

Todo El Tiempo: 560