Repara tus cosas Comunidad Tienda

ResMed VPAP Auto 25 Blower Unit Replacement Replacement

Introducción

The blower unit fails when the device becomes overused and outdated. It also fails as a result of dust clogging up the intake. Replacements extend for only a certain amount of time. Replacing the blower unit will save lots of money compared to buying a whole new unit. Eventually, a full unit replacement is necessary.

Qué necesitas

  1. ResMed VPAP Auto 25 Blower Unit Replacement Replacement, Blower Unit: paso 1, imagen 1 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement, Blower Unit: paso 1, imagen 2 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement, Blower Unit: paso 1, imagen 3 de 3

    • Remove the four 26.7 mm T3 Torx screws from the bottom side of the ResMed VPAP Auto 25.

    Editar

  2. ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 2, imagen 1 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 2, imagen 2 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 2, imagen 3 de 3

    • Flip the device over.

    • Pry the outermost plastic cover off with the metal spudger until the cover is loose and able to be removed.

    Editar

  4. ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 3, imagen 1 de 2 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 3, imagen 2 de 2

    • Pull off the front cover to reveal the internal components.

    Editar

  5. ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 4, imagen 1 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 4, imagen 2 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 4, imagen 3 de 3

    • Loosen the motherboard from the rubber dowels holding it in place and unplug the screen components.

    Editar

  6. ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 5, imagen 1 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 5, imagen 2 de 3 ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 5, imagen 3 de 3

    • Remove the three 26.7 mm T3 Torx screws from the now visible rubber fan motor cover.

    • Lift off the rubber fan motor cover, revealing the fan motor.

    Editar

  7. ResMed VPAP Auto 25 Blower Unit Replacement Replacement: paso 6, imagen 1 de 1

    • Unplug the blower unit cable.

    • Remove the fan motor blower unit.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Un comentario

where can we get a new motor?

ed allen - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 5

Todo El Tiempo: 297