Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Thread the needle thread through the invisible zipper foot hole.
-
Pull the needle thread through the zipper foot hole.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Locate the stitch lines of where the broken zipper was sewn on both sides of your garment.
-
Use a seam ripper to carefully rip out both of the stitching lines.
-
Remove old invisible zipper.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the skirt inside out.
-
Place the replacement invisible zipper on the table, with the teeth side pointing up and the zipper pull facing down.
-
Unzip the invisible zipper. Line up the left side of the tape of the invisible zipper with the left side of your fabric.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pin the tape of the zipper to your garment's fabric perpendicular to the invisible zipper.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Place the teeth of the left side of the zipper into the right side of the invisible zipper foot.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Sew a straight line carefully, removing pins as you go.
-
Repeat Steps 5-8 on the right side of your garment.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn the skirt right-side out again, so you don't see the zipper teeth.
-
Rotate the fabric so the zipper foot is perpendicular to the zipper tape.
-
Position the zipper foot on top of the fabric 1/8th of an inch from where the zipper tape meets the garment.
-
Sew back and forth at least 6 times to seal the end.
-
Flip garment over to see the stitch line you just made. Cut off excess zipper tape.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull up your newly replaced zipper.
-
Be proud of yourself! You've just replaced an invisible zipper!
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.