Introducción

Step-by-step guide to replacing your phone's logic board.

Partes

No se requieren partes.

Flip phone to see back cover.
  • Flip phone to see back cover.

  • Using either finger or spugder tool press button located near the top of phone by the antenna.

Agregar Comentario

Pry up back plate from phone to reveal battery.
  • Pry up back plate from phone to reveal battery.

  • Push button near bottom of battery using either your finger of the spudger. This will release the battery.

Agregar Comentario

  • Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.

Agregar Comentario

  • Simultaneously press indicated buttons on both sides of phone.

Agregar Comentario

  • Separate back plate from the rest of phone.

  • Make sure to not pull, there is a wire (circled on image) connecting the two plates.

Agregar Comentario

  • Gently lift logic board from back plate.

Agregar Comentario

  • Place logic board on front cover.

  • Unsnap orange wire that connects the logic board to keypad sensor to allow the logic board to move freely.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Equipo

Cal Poly, Team 30-40, Garner Spring 2010 Miembro de Cal Poly, Team 30-40, Garner Spring 2010

CPSU-GARNER-S10S30G40

4 Miembros

14 Guías creadas

Quero comprar esse aparelho, alguém tem para vender?

Karison Mesquita - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 1

Últimos 30 Días: 3

Todo El Tiempo: 1,936