Repara tus cosas Comunidad Tienda

Replacing Creative Zen X-Fi Midsection Plate

Introducción

This midsection plate is used to separate and organize the interior of the device.

Qué necesitas

  1. Replacing Creative Zen X-Fi Midsection Plate, Detaching Front Case: paso 1, imagen 1 de 3 Replacing Creative Zen X-Fi Midsection Plate, Detaching Front Case: paso 1, imagen 2 de 3 Replacing Creative Zen X-Fi Midsection Plate, Detaching Front Case: paso 1, imagen 3 de 3

    • Using a spudger, wedge the tip between the front and back case to pry them apart.

    • Be careful to not apply excessive force since there are six fasteners on the screen's side that holds the cases firmly together.

    Traducir

  2. Replacing Creative Zen X-Fi Midsection Plate, Rubber Button Cover: paso 2, imagen 1 de 1

    • The black rubber button pad can be removed by simply picking it up.

    Traducir

  3. Replacing Creative Zen X-Fi Midsection Plate, Button Input Chip Part 1: paso 3, imagen 1 de 1

    • Flip the LCD screen off the midsection plate to gain access to the space around the input button chip.

    Traducir

  5. Replacing Creative Zen X-Fi Midsection Plate, Button Input Chip: paso 4, imagen 1 de 1

    • Using a spudger, pry off the button input chip from the mid-section of the device. To gain best leverage, start at the bottom right corner and level your way up the side of the chip.

    • Be aware that the button input chip is glued to the mid-section, so some extra force may be required.

    Traducir

  6. Replacing Creative Zen X-Fi Midsection Plate, Access Midsection Plate: paso 5, imagen 1 de 1

    • Lift open the LCD screen and button input chip to access the entire midsection plate.

    Traducir

  7. Replacing Creative Zen X-Fi Midsection Plate, Unscrew below Button Chip: paso 6, imagen 1 de 1

    • Use a Phillips Head screwdriver to unscrew the three 3/16 inch screws that were underneath the button input chip.

    Traducir

  8. Replacing Creative Zen X-Fi Midsection Plate, Unscrew below LCD Screen: paso 7, imagen 1 de 1

    • Use a Phillips Head screwdriver to unscrew the three 3/16 inch screws that were underneath the LCD screen.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 2 otros colaboradores

Westley Courchene

Miembro Desde 01/13/15

3,362 Reputación

14 Guías creadas

Insignias: 22

+ 19 más insignias

Equipo

USF Tampa, Team 1-1, Remmell Fall 2015 Miembro de USF Tampa, Team 1-1, Remmell Fall 2015

USFT-REMMELL-F15S1G1

5 Miembros

14 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 132