Saltar al contenido principal

Partes

No se especificaron partes.

  1. Gently use tweezers to detach the white vision wire harness, located directly under the feed tube.
    • Gently use tweezers to detach the white vision wire harness, located directly under the feed tube.

    • Another small tool or your fingers will work for this.

  2. Remove the two 1-1/4" screws on either side of the circuit board using a 3/32" allen wrench.
    • Remove the two 1-1/4" screws on either side of the circuit board using a 3/32" allen wrench.

  3. Separate the solenoid from the gun's body by gently pulling it upwards.
    • Separate the solenoid from the gun's body by gently pulling it upwards.

  4. Slide the metal body out of the plastic shell by holding one in each hand and gently pulling apart.
    • Slide the metal body out of the plastic shell by holding one in each hand and gently pulling apart.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Shane Villalpando

Miembro Desde 02/02/15

1,022 Reputación

10 Guías creadas

Equipo

Cal Poly, Team 8-42, Amido Winter 2015 Miembro de Cal Poly, Team 8-42, Amido Winter 2015

CPSU-AMIDO-W15S8G42

4 Miembros

10 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 47