Partes

No se requieren partes.

Tool on left - PH000 screwdriver
  • Tool on left - PH000 screwdriver

  • Tool on right - iPod fix-it tool

  • Soldering Iron

Agregar Comentario

Locate the 3 black screws on the bottom of the camera and the 2 gray screws on each side of the camera. Remove them with a PH000 screwdriver.
  • Locate the 3 black screws on the bottom of the camera and the 2 gray screws on each side of the camera. Remove them with a PH000 screwdriver.

Agregar Comentario

  • Locate the gray band that you removed the screws from; this holds the two halves of the camera together. Use an iPod fix-it tool to pry the gray band loose and remove it.

Agregar Comentario

  • Use the iPod fix-it tool to separate the back panel from the camera.

Agregar Comentario

  • Use the iPod fix-it tool to carefully pry the screen from the logic board.

  • There's a ribbon cable that connects the screen to the logic board.

Agregar Comentario

  • This view shows the ribbon cable that connects to the screen.

Agregar Comentario

  • Flip the screen down. To disconnect the ribbon cable from the logic board, rock each end of the brown metal retainer that holds the ribbon cable in place until the ribbon disconnects.

Agregar Comentario

  • Remove the two screws on the top edge of the circuit board to the right of the viewfinder.

Agregar Comentario

  • To connect the new screen, solder the wires in place and connect the ribbon cable to the logic board.

Agregar Comentario

  • Unthread the four wires running across the top of the viewfinder from the plastic brackets holding them in place.

Agregar Comentario

  • Remove the two black screws threaded vertically into the top of the viewfinder. Loosen the flash and circuit board for more accessibility. This will allow for the viewfinder to be replaced.

Agregar Comentario

  • Remove the small piece of tape holding the four wires to the viewer.

Agregar Comentario

  • Remove the two screws on the top edge of the circuit board, to the right of the viewer.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Andrew

Miembro Desde 27/09/12

7 Reputación

1 Guía escrita

Equipo

Ohio State, Team 1-2, Buehl Fall 2012 Miembro de Ohio State, Team 1-2, Buehl Fall 2012

OSU-BUEHL-F12S1G2

3 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 3

Todo El Tiempo: 756