Saltar al contenido principal

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Removing Magellan RoadMate 1200 Back Cover

Qué necesitas

  1. Removing Magellan RoadMate 1200 Back Cover, Back Cover: paso 1, imagen 1 de 2 Removing Magellan RoadMate 1200 Back Cover, Back Cover: paso 1, imagen 2 de 2
    • Remove 4 rubber caps covering each screw by inserting the screwdriver into the side of cap and prying back and forth.

    • Please note: this is a tedious process, but be patient.

  2. Removing Magellan RoadMate 1200 Back Cover: paso 2, imagen 1 de 1
    • Remove the 4 screws holding the cover in place using a Phillips #00 screwdriver.

  3. Removing Magellan RoadMate 1200 Back Cover: paso 3, imagen 1 de 2 Removing Magellan RoadMate 1200 Back Cover: paso 3, imagen 2 de 2
    • Open the back cover.

    • Lift the cover slowly and carefully; the speaker is screwed on the back cover and is connected to the circuit board.

  4. Removing Magellan RoadMate 1200 Back Cover: paso 4, imagen 1 de 2 Removing Magellan RoadMate 1200 Back Cover: paso 4, imagen 2 de 2
    • Disconnect the speaker from the terminal.

    • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Ross Light

Miembro Desde 04/12/10

217 Reputación

6 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 3

Todo El Tiempo: 3,467