Introducción

Need to get inside the amp? Remove the back panel!

Be sure to unplug the device before proceeding.
  • Be sure to unplug the device before proceeding.

  • Use a Phillips #0 screwdriver to remove the four 21.7mm screws holding the back panel to the frame.

Agregar Comentario

Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.
  • Once the screws are out, use a plastic opening tool or spudger to pry the top of the back panel open. There may be some resistance, but it will eventually pry loose.

Agregar Comentario

  • Once the top is separated, use your hand to remove the back panel from the unit.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Greg Sawers

Miembro Desde 27/09/12

71 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 24-30, Regan Fall 2012 Miembro de Cal Poly, Team 24-30, Regan Fall 2012

CPSU-REGAN-F12S24G30

5 Miembros

7 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 11

Últimos 30 Días: 51

Todo El Tiempo: 3,720