Saltar al contenido principal


Un perno plano y hundido con cabeza Allen estaba arrancado, la llave hexagonal no tenía agarre y el perno tampoco podía agarrarse con tenazas. Era un perno grueso, por lo que taladrarlo hubiera sido muy difícil.


No se especificaron partes.

  1. Corta un zócalo en la cabeza del perno.
    • Corta un zócalo en la cabeza del perno.

    • Coloca un destornillador en el zócalo y golpea con un martillo en el sentido contrario a las agujas del reloj para aflojar el perno.

    • Quita el perno con el destornillador.

    How do you cut a slot in the stripped steel screw head which is half an inch inside the faucet handle and access hole is only 1/4 inch ?

    Singh - Contestar

Linea de Meta

39 personas más completaron esta guía.

Un agradecimiento especial a estos traductores:

en es


¡ Gianfranco Sergi nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›


Miembro Desde 17/02/12

567 Reputación

2 Guías creadas

6 comentarios

Use the same technique for Philips or crosshead screws.

Use a grinding / cutting disk, not a saw blade. Apply the rotating cutting disk gently, do not force or it will break.

If this is a toughened steel or stainless steel bolt (much tougher), it will be best to use a reinforced cutting disk.

Use a dusk mask to avoid breathing the dusk from the disk !

(No, I don't usually, but I should !)

Frank B - Contestar

While this works it is very difficult to not ruin the material around the bolt.

What I do is use a torx bit. size one up that is slightly larger then the hole and then firmly tap it in. atttach your drive handle a turn slowly while pushing down. this will normally break it free.

Also before your get to this point try putting your allen key in the hole and smack it with a hammer. sometimes the force of the hit will cause the metal to "break" enough that the allen screw wont strip.

Jamie Mcguire -

There are also specifically designed screw extractors made for this. These tools are generally two-sided: one side is used to drill the hole, while the other is inserted to extract. If the process works, the surrounding area is undamaged.

Karl Kaufmann - Contestar

Use another Allen bolt to weld over it and then you can easily remove the Allen bolt with the help of Allen key

Tushar Pednekar - Contestar

And if for any reason if you can't weld then just drill the head of the Allen bolt so it's shears off. And then u can easily remove the rest

Tushar Pednekar - Contestar

Ive always had the best luck using torx bits if not rusted in.

jazzberry_tpt1 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 23

Ultimos 7 días: 144

Ultimos 30 días: 688

Todo El Tiempo: 236,752