Saltar al contenido principal

Introducción

Two tools required for the completion of this task include a PH1 screwdriver, and a prying tool.

All screws on this device are 10mm (0.393 in).

  1. Place the prying tool in between the hair straightener and the aligning cap. Push forwards on the prying tool to pop off the aligning cap.
    • Place the prying tool in between the hair straightener and the aligning cap.

    • Push forwards on the prying tool to pop off the aligning cap.

  2. Remove the screws with the Phillips #1 screwdriver located underneath the aligning cap, one on each side of the straightener. Use the prying tool to remove the aligning rods after the removal of the screws. Gently separate each half of the hair straightener.
    • Remove the screws with the Phillips #1 screwdriver located underneath the aligning cap, one on each side of the straightener.

    • Use the prying tool to remove the aligning rods after the removal of the screws.

    • Gently separate each half of the hair straightener.

    • The spring located in the middle of this mechanism may pop out and can get lost very easily. Try to separate the two components slowly.

  3. Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now

    Kits de Reparación de Batería de MacBook Air

    A partir de $69.99

    Buy Now
  4. After the hair straightener is separated, use a Phillips #1 screwdriver to remove the two  screws  located on the lower half of the straightener. Use the prying tool to remove the hinge cover.
    • After the hair straightener is separated, use a Phillips #1 screwdriver to remove the two screws located on the lower half of the straightener.

    • Use the prying tool to remove the hinge cover.

  5. Pull upwards while pulling outwards to disconnect the wire from the housing. Pull upwards while pulling outwards to disconnect the wire from the housing.
    • Pull upwards while pulling outwards to disconnect the wire from the housing.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Benjamin Yohe

Miembro Desde 11/07/18

255 Reputación

2 Guías creadas

Equipo

IUPUI, Team S3-G3, Wilson Summer 2018 Miembro de IUPUI, Team S3-G3, Wilson Summer 2018

IUPUI-WILSON-SU18S3G3

5 Miembros

2 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 5

Últimos 7 Días: 11

Últimos 30 Días: 34

Todo El Tiempo: 196