Saltar al contenido principal

Introducción

Usa esta guía para reemplazar el ensamblaje de altavoz en tu Nexux 5.

  1. Usa una herramienta de apertura de plástico para liberar los clips en la parte superior de cada lado de la tapa trasera. La parte inferior está sujeta con espuma adhesiva. Podrás finalmente liberar la tapa trasera utilizando una púa de apertura. Es mejor evitar hacer palanca alrededor de la ranura de la tarjeta SIM., ya que el plástico aquí es muy delgado y puede romperse al hacer palanca.
    • Usa una herramienta de apertura de plástico para liberar los clips en la parte superior de cada lado de la tapa trasera.

    • La parte inferior está sujeta con espuma adhesiva. Podrás finalmente liberar la tapa trasera utilizando una púa de apertura.

    • Es mejor evitar hacer palanca alrededor de la ranura de la tarjeta SIM., ya que el plástico aquí es muy delgado y puede romperse al hacer palanca.

    Wireless QI and NFC.

    Once I have put everything together with the new battery in place, I have as last replaced the plastic back cover, snapping all the clips back around the edges of the phone. Alas, I was quick to realise the QI Wireless charging has ceased to work.

    I almost blamed the battery, or worse, me.

    QUICK TIP: there is actually another clip in the middle of the plastic back cover - just press with your thumb just above the 'S' in NEXUS emblem and, voila! Snaps back in.

    Wireless charge and NFC - works, once again.

    cwioro - Contestar

    you just saved me like 30 bucks. thank you so much.

    Robert Nolan -

    + 1, had the same issue and pressing just near the S fixed it! Thanks a lot!

    nicco82 -

    Just a me too, I had to press above the S and it was quite a snap

    Erik Karlin -

    There seems to be two contacts that snap into place. One is in line with the led pretty much in the middle of the phone and the second one in line with the camera lens on the opposite side to the lens. The middle one for me snapped pretty lightly, but the side one required a bit more pressure. After that the nfc started working again. Thanks for posting this!

    Dennis Millner -

    Is it hard to remove the battery door? Worried I might damage it.

    Ash - Contestar

    When I openend the back cover I damaged two clips. One about 2.5cm (1 inch) below the volume controls and one on the other side about same height. The cover fits good without those two but on one side there is a small gap where the clip broke. But I have a hard cover protector on my phone so it's not that bad.

    simonlwheeler - Contestar

    The case around the sim slot is pretty thin and easy to break, best to avoid using the pry tool at this point.

    Aled Morris - Contestar

    Excellent tip, should be included in the main guide.

    fprades - Contestar

    Hey Author, i need to ur expert advice...i replaced my nexus 5's back cover. since the new one did not have the vibrators battery i had to take it from the old one and connect it to the new one...on removing i noticed that it was stuck to the cover by a glue

    Question: what glue to use to hold the battery to the cover?

    suwaid akbar - Contestar

    Any adhesive will do. I used a hot glue gun. You shouldn't need expert advice to figure that out. Use your head.

    tjt263 -

    The case around the volume control is also pretty thin.... I broke mine prying so avoid the pry there too.

    Also my back had glue at the bottom and I haven't seen mentioned

    kornerson - Contestar

  2. Remueve los cuatro tornillos de Phillips #00 que sujetan el ensamblaje de altavoz. Usa una herramienta de apertura de plástico para levantar el ensamblaje del altavoz del teléfono.
    • Remueve los cuatro tornillos de Phillips #00 que sujetan el ensamblaje de altavoz.

    • Usa una herramienta de apertura de plástico para levantar el ensamblaje del altavoz del teléfono.

Conclusión

Para volver a ensamblar tu dispositivo, sigue estas instrucciones en orden inverso.

18 personas más completaron esta guía.

Un agradecimiento especial a estos traductores:

100%

¡ Mariana nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›

Chris Willis

Miembro Desde 03/10/14

1,371 Reputación

3 Guías creadas

Equipo

USF Tampa, Team 13-4, Staggers Fall 2014 Miembro de USF Tampa, Team 13-4, Staggers Fall 2014

USFT-STAGGERS-F14S13G4

3 Miembros

13 Guías creadas

Fantastic! My speaker assembly from iFixit arrived today, and about 20 minutes later I'd just saved myself the $600 dolalrs of buying a new phone. Great site, thanks guys!

Charles Comenos - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 6

Ultimos 30 días: 22

Todo El Tiempo: 21,295