Introducción
Usa esta guía para reemplazar la tapa trasera de tu Samsung Galaxy A50.
Necesitarás adhesivo de reemplazo para volver a conectar la tapa trasera al ensamblar el dispositivo.
Qué necesitas
-
-
Comienza por apagar el teléfono.
-
Calienta un iOpener y aplícalo a la tapa trasera para ablandar el adhesivo.
-
-
-
Inserta una púa de apertura en la parte inferior del teléfono, cerca del puerto USB-C.
-
Desliza la púa de apertura hasta la esquina inferior izquierda.
It would be much better to attempt the opening from the top of the phone as there is a delicate flex PCB antenna at the bottom just where you stick the pick in that can get damaged.
Wish I would have read your comment before, since I destroyed that cable while opening my phone... It's a cable for microphone, speaker and headphone jack. Replacing it was a real pain because it's glued but luckily I was able to find a spare.
H.W -
-
-
-
-
Inserta una cuarta púa de apertura debajo de la esquina derecha superior de la tapa trasera.
-
Desliza la punta de la púa de apertura a lo largo del lado del teléfono hasta la esquina inferior derecha para cortar el adhesivo.
-
Deja la pua de apertura en la esquina inferior derecha para evitar que el adhesivo se vuelva a sellar.
-
-
-
Remueve la tapa trasera.
Very straight forward and simple replacement to do with the right tools, I used my hot air gun work station so this might have been alot easier for me then someone without one? Hair dryers work too, just in case a hot airgun station is not available to you dont worry you can do this repair without, but some form of heat will make life alot simpler :)
-
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Aplica un nuevo adhesivo donde sea necesario después de limpiar las áreas relevantes con alcohol isopropílico (>90%). Asegura la nueva tapa trasera con adhesivo precortado o cinta adhesiva de doble cara.
Para volver a montar el dispositivo, sigue estas instrucciones en orden inverso.
Aplica un nuevo adhesivo donde sea necesario después de limpiar las áreas relevantes con alcohol isopropílico (>90%). Asegura la nueva tapa trasera con adhesivo precortado o cinta adhesiva de doble cara.
Cancelar: No complete esta guía.
16 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
¡ Mariana Roca nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
Un comentario
Thank you for this write up, I wanted to insure there were no connections and overall it's just something I practice to make sure to double check rather a back cover has any hidden surprises, Trust me I've learned from experience not to Assume anything, lol. Take care, and thanks
Nur ein kleiner Tippfehler-Hinweis: (Überhitze das Gerät nicht)
Jonas Hahn - Contestar
OK, korrigiert. Das kann übrigens jeder machen, iFixit ist ein Wiki.
VauWeh -
how long should the heat pack be used for?
David Hall - Contestar
The heat pack is in the wrong position in photo - the glue that you are heating is actually all around the edge of the phone!
David Hall - Contestar