Introducción
¿La batería no aguanta mucho? Cámbiala.
Qué necesitas
-
-
Inserta una herramienta de apertura de iPod en la raja entre la frente del iPod, blanca y de plástico, y su parte posterior, metálica. Ayuda sujetar el iPod arriba y abajo (foto) y presionar para ayudar a pasar el labio. Una vez insertada la herramienta, pásala a lo largo de la raja para liberar las cinco aletas que mantienen el iPod asemblado.
-
-
-
-
Separa la batería del adhesivo que la pega al iPod.
-
Coloca la batería al lado del iPod (todavía está conectada a la placa electrónica).
-
-
-
Desconecta cuidadosamente el conector de batería (blanco) de la placa electrónica. Asegurate de tirar del propio conector y no de los cables.
-
Para reensamblar tu dispositivo, sigue estas instrucciones en orden inverso.
Para reensamblar tu dispositivo, sigue estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
32 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
¡ Quentin Gillard nos está ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
2 comentarios
There are so many iPods, it's confusing as to what battery to buy. I have 3 of these old bricks and sure it's battery time. Can you please provide a link to the specific battery for this (above) iPod?
The iPod that I,m trying to resssurect has a connection that has 50t pin connection. I ordered the battery shown in the picture and now have to exchange it
Boy, are these cases hard to open! I got nowhere with the spudger, but I did have success using duct tape. This is worth trying as it reduces the likelihood of scratching the case. Make a tab by sticking duct tape to the metal case starting on the side down by the scrolll wheel and ending up where the metal case ends on the firewire side. Fold excess duct tape back on itself so that it is 2x thick anywhere it isn’t stuck to the iPod. This is where you are going to grab it. Rub the duct tape with a spudger or a fingernail where it touches the iPod to make it stick better. Make a similar tab on the other side. Now grab the iPod in your right hand with your thumb at the 1/8” audio connector, squeeze gently, and pull on one of the duct tape tabs. (I stared with the one of the lock button side, but I don’t think it matters.) It is smooth sailing once the case starts to open up. Clean off any duct tape residue with alcohol wipes before re-assembly.
R Calhoun - Contestar
Well, maybe for you because you have baby hands and, it Took me less Then a minute to do it
Matthew Cabanas -