Saltar al contenido principal

Introducción

Usa esta guía para reemplazar la batería.

Nota:

Si hay un film delgado de plástico en tu batería de reemplazo, no intentes removerlo. Está pegado y protege el paquete de batería mientras está dentro de la MacBook.

    • Antes de continuar, apaga tu máquina. Cierra la pantalla y colócala en una superficie suave con la parte superior hacia abajo.

    • Usa un destornillador P5 Pentalobe para remover los diez tornillos que sujetan la caja inferior:

    • Dos tornillos Pentalobe P5 de 9 mm

    • Ocho tornillos Pentalobe P5 de 2,6 mm

    Pulling the fan cable out was terrifying but you actually just pull on the cable itself. No way to get any leverage at the connector to dislodge it. Did come out easily but like I said, scared me!

    allison - Contestar

    Draai de schroefjes voorzichtig los en leg ze op een stabiele plek neer en let erop dat de schroefje een verschillende lengte hebben.

    bwgvanderveer - Contestar

    I thought I could replace my 256 Gb SSD with 512? regards

    ola m - Contestar

    Do you have good Test Point Voltages? It appears there are silver colored Test points on the I/O Board. I am working on a water spill and trying to troubleshoot if both the I/O board and the Logic need replaced.

    andrew - Contestar

    It's probably not necessary but may be a little safer to completely discharge the old battery before replacing it.

    Larry Smith - Contestar

    tell a model that was not inferior to the speed of the one in the laptop.

    Thank you

    ilyabuhov - Contestar

    Do i need to order tools separately to replace the battery i just ordered?

    anne uhlir - Contestar

    im looking for a Logic Board for a

    Apple - MacBook Air® - 13.3" Display - Intel Core i5 - 8GB Memory - 128GB Flash Storage (Latest Model) - Silver Model: MQD32LL/A

    Any help is appreciated.

    Jamie Comstock - Contestar

    P5 pentalobe screwdrivers are too big! The correct size for these screws are p4 pentalobe. P5 pentalobe was just able, with difficulty, to turn some of the screws. If the screws were at all tight, my p5 was unable to get them out, and started to strip the screws. A p4 screwdriver fit better and removed the screws with ease. (I was using high quality Wiha brand screwdrivers.)

    William Skinner - Contestar

    Very simple installation. The screwdriver heads were exactly what we’re needed, one head for the outside case screws, the other for the screws holding the battery in place. The computer started right up. Now to see how the battery holds up, but I have a good feeling about this!

    Dennis Eaton - Contestar

    My P5 and the T5 worked perfectly with my early 2015 Air 13”! And it is super fast! Thank you iFixit!

    Pennny Beach - Contestar

    The supplied kit and instructions worked perfectly!

    Nikolay Andreev - Contestar

    Comments that the P5 pentalobe are too large are absolutely spot-on. There is no way the P5 pentalobe bit I have will work with the MacBook Air without destroying the screws. Hard target search for P4 pentalobe bit in progress…..

    joemoog - Contestar

    Bonjour j’aimerais changer mon SSD de 128 Go pour en mettre un de 512 Go. Je ne sais pas ce qu’il faut prendre car il faut qu’il soit compatible avec le macbook air A1466. J’aurais vu un Samsung Evo 970 500 Go mais si je ne me trompe pas, il faut un adaptateur.

    Merci pour votre aide.

    chicco33 - Contestar

    oui, vous aurez besoin d’un adaptateur, pour completez le changement.

    Dan -

    The tool kit should include tweezers for re-inserting the battery connector.

    Andre Clement - Contestar

  1. Cuña tus dedos entre la pantalla y la caja inferior y tirs hacia arriba para hacer estallar la caja inferior del aire.
    • Cuña tus dedos entre la pantalla y la caja inferior y tirs hacia arriba para hacer estallar la caja inferior del aire.

    • Quita la caja y déjala a un lado.

    There is a nub on the inside of the case which is attached to the battery. When you try to pull it open, it appears to be attached to the plastic casing of the battery, which sometimes splits. I gently unhooked the nub from the battery before removing the case fully. This seems to happen if the battery has suffered some drop damage (plastic parts broken around screws and parts of plastic frame split). Just an FYI in case your lower case doesn't pull away easily.

    Jeannie Crowley - Contestar

    When closing this back up make sure that the antenna cable is tucked away neatly

    Gabriel - Contestar

    So this is a legit back cover for MacBook Air?

    ASHANTI SMITH - Contestar

  2. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  3. Toma la lengüeta de plástico transparente conectada al conector de la batería y jálala hacia el borde frontal de la Air para desconectar la batería de la placa lógica.
    • Toma la lengüeta de plástico transparente conectada al conector de la batería y jálala hacia el borde frontal de la Air para desconectar la batería de la placa lógica.

    • No levantes hacia arriba en el conector mientras lo desconectas.

    @&?! - pulled plastic tab on new battery to line up with logic board pins look to be coming out of male connector? Argh?!

    James Bowkett - Contestar

    Can expect anyone from ifixit to get back to me?

    James Bowkett - Contestar

    Hi James,

    It may be that one of the pins did not lock in properly into the plastic housing. You can try pushing the corresponding wire into the connector housing to try to lock the pin in.

    If that does not help, please respond to my email. Thanks!

    Arthur Shi -

  4. Remueve los siguientes cinco tornillos que sujetan la batería a la caja superior:
    • Remueve los siguientes cinco tornillos que sujetan la batería a la caja superior:

    • Tres tornillos T5 Torx de 6.3 mm

    • Dos tornillos T5 Torx de 2.4 mm

    When going in reverse, it's easier to do step 3 before 4.

    John Heffernan - Contestar

  5. Al manipular la batería, evita apretar o tocar las cuatro celdas de polímero de litio expuestas.
    • Al manipular la batería, evita apretar o tocar las cuatro celdas de polímero de litio expuestas.

    • Levanta la batería de su borde más cercano a la placa lógica y retírela de la caja superior.

    • Si estás instalando una batería nueva, debes calibrarla luego de la instalación.

    • Cárgala hasta el 100% y luego sigue cargándola durante al menos 2 horas más. Luego, desenchúfala y úsala normalmente para drenar la batería. Cuando veas la advertencia de batería baja, guarda tu trabajo y mantén tu laptop encendida hasta que se duerma. Espera al menos 5 horas, luego cárgala de forma ininterrumpida hasta 100%.

    • Si notas alguna conducta o problema inusual luego de instalar tu batería nueva, podrías necesitar restablecer el SMC de tu MacBook Pro.

    Two Questions and a Comment:

    1) “Allow the battery to drain overnight” - Should the computer shut down automatically (during the first drain, as well)? If not, what percentage should the battery reach before charging it to 100%?

    2) While the battery is draining, can I use the computer?

    When installing the new battery, I found it much easier to insert the battery connector before screwing in the battery.

    Paul Larkin - Contestar

    When reinserting the battery, plug in the battery connector before screwing the battery into place. Some wiggle room is required to reconnect the batter and tweezers will help with the plugging in.

    Andre Clement - Contestar

Conclusión

Para volver a ensamblar tu dispositivo, sigue las instrucciones en orden inverso.

175 personas más completaron esta guía.

Un agradecimiento especial a estos traductores:

100%

Estos traductores nos están ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›

USB wird nach Batterie Wechsel nicht mehr erkannt!

Stemmbrett - Contestar

Easy change, thank you so much iFixit.

Jordano Moscoso - Contestar

Excellent, thank you.

karlgezer - Contestar

My macbook air logic board damaged but reason has not addressed by service center. They are asking to pay 700 $ and i ca not afford this much amount what is the best solutions in India . i am being &&^&@@ up buying mac book on monthly EMI. sad

Sudhir Pandey - Contestar

i was disconnecting the connector from the logic board .. Do i need to exchange the whole logic board ..?

okonmaya - Contestar

This was my first experience using iFixit to buy parts, tools and use the guide. I will be coming back here from now on, this guide was great and the kit arrived on time and with everything that I needed.

Devin Whitney - Contestar

Perfect! You guys are the coolest…..thanks for your help….again!

mfogelquist - Contestar

That was pretty easy. Just be careful when you insert the connector into the logic board socket. You’ll have to give the wires an “S” bend, then insert the connector straight in, don’t lift on it or the socket might come off the board. As you push the connector in, use your other hand to support the socket.

Maybe it would be easier to first insert the connector while the battery is sitting a little out of position, and then second pushing the battery into position.

Gregory Holmberg - Contestar

Excellent guide. It took all of 15 minutes start to finish, including cleaning out the dust inside my MBA. Thanks!

Dave Gesell - Contestar

I was a bit nervous before replacing the battery on my own, but following this guide made it so easy. I finished it in 12 minutes including cleaning the interior. Thank you!!

Zsolt Repasy - Contestar

Great instructions. Everything seems to be working fine…minor problem was that I had to do SMC-reset because the Battery indicator showed red even though the battery was charged "100%” and OS X informed “Battery is empty and MacBook Air has to shut down”…but the problem was solved with SMC-reset. Have been using MacBook Air Middle 2013 since then (several weeks) with the new battery and everything seems to be working great. Battery was calibrated accordingly before the “red indicator 100% shut down”-thing appeared. Thank you.

Antti Alutoin - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 110

Últimos 7 Días: 725

Últimos 30 Días: 2,951

Todo El Tiempo: 159,781