Introducción
Clic. Clic. Pfft. ¿Su botón de inicio dejó de hacer clic? Utilice esta guía para reemplazarlo. Esta guía es para reemplazar la cubierta del botón de inicio de plástico. Si necesita reemplazar el interruptor del botón de inicio funcional, vaya a esta guía.
Qué necesitas
-
-
Con la pistola de aire caliente puesta en "bajo", comience a calentar la parte inferior del toque cerca del botón de inicio.
-
-
-
Inserte el borde de una herramienta de apertura del iPod entre el panel de vidrio frontal y el bisel de plástico negro cerca del botón de inicio.
-
Presione el borde inferior del panel frontal hacia arriba, teniendo cuidado de no doblar el vidrio excesivamente.
-
-
-
-
Tire con cuidado de la parte superior del ensamblaje del panel frontal alejándolo del adhesivo que lo sujeta al tacto, teniendo en cuenta el corto cable del digitalizador que conecta los dos componentes.
-
-
-
Inserte una herramienta de apertura de plástico debajo del caucho sosteniendo el botón de inicio en su lugar.
-
Deslice la herramienta alrededor del perímetro del botón, levantando a medida que avanza.
-
Levante el botón de inicio del dispositivo.
-
Para volver a montar el dispositivo, siga estas instrucciones en orden inverso.
Para volver a montar el dispositivo, siga estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
69 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
Estos traductores nos están ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
11 comentarios
"To reassemble your device, follow these instructions in reverse order."
So Nice. Its Fully help
can you make professional step by step tutorial on how to put the touch back together like the one you made to take it apart ?
If you follow the guide from the bottom to the top, you can reassemble the device. If you disassembled the phone farther than the Home Button guide shows, go back to the device page and follow the guide that matches your device.
Hmm I was careful to not break any wires (all the wires looked fine to me) and plug the thing back in but the screen stays black after I press the power button :/
NO you cannot follow instructions in reverse BECAUSE you need focking adhesive to re apply the FOCKING SCREEN!
You are right. the adhesive is here: iPod touch (4th Gen) Adhesive Strips
nirv -
i timed it and it took me 5 minutes and i think it should be rated 1 in difficulty