Repara tus cosas Comunidad Tienda

RedOctane X-Plorer Keys Replacement

Introducción

The guitar keys can wear out over time or stop working completely. This guide demonstrates how to successfully remove the keys to diagnose internal problems.

Qué necesitas

  1. RedOctane X-Plorer Keys Replacement, Rear Case: paso 1, imagen 1 de 2 RedOctane X-Plorer Keys Replacement, Rear Case: paso 1, imagen 2 de 2

    • Remove the strap by pulling it off of the mounts located on the body and neck.

    Traducir

  2. RedOctane X-Plorer Keys Replacement: paso 2, imagen 1 de 3 RedOctane X-Plorer Keys Replacement: paso 2, imagen 2 de 3 RedOctane X-Plorer Keys Replacement: paso 2, imagen 3 de 3

    • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

    • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

    • These screws can also be Torx on some models.

    • Pull off the rear case.

    Traducir

  4. RedOctane X-Plorer Keys Replacement: paso 3, imagen 1 de 3 RedOctane X-Plorer Keys Replacement: paso 3, imagen 2 de 3 RedOctane X-Plorer Keys Replacement: paso 3, imagen 3 de 3

    • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

    • Pull off the top shell of the neck to expose the internal features.

    Traducir

  5. RedOctane X-Plorer Keys Replacement, Keys: paso 4, imagen 1 de 3 RedOctane X-Plorer Keys Replacement, Keys: paso 4, imagen 2 de 3 RedOctane X-Plorer Keys Replacement, Keys: paso 4, imagen 3 de 3

    • Use a screwdriver to remove the 10 mm Phillips #1 screws from the key sensor board.

    • Lift up on the key sensor board to remove it from the guitar neck.

    • When using the screwdriver, make sure to avoid puncturing the wires.

    Traducir

  6. RedOctane X-Plorer Keys Replacement: paso 5, imagen 1 de 1

    • Using your fingers, remove the rubber pad to expose the colored keys.

    Traducir

  7. RedOctane X-Plorer Keys Replacement: paso 6, imagen 1 de 2 RedOctane X-Plorer Keys Replacement: paso 6, imagen 2 de 2

    • Reach one finger under the guitar to push the key out of the casing.

    • Repeat this step for the four remaining keys.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Ashley Slocum

Miembro Desde 04/18/18

189 Reputación

1 Guía escrita

Insignias: 8

+ 5 más insignias

Equipo

Cal Poly, Team S17-G1, Livingston Spring 2018 Miembro de Cal Poly, Team S17-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S17G1

3 Miembros

9 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 10

Ultimos 30 días: 31

Todo El Tiempo: 3,932