Repara tus cosas Comunidad Tienda

Razer Blade RZ09-0102 Fan Replacement

Introducción

The fans in your laptop are important for keeping the internal components from overheating. So it's important to preform maintenance on them to keep your laptop working properly. Whether to replace the fans or just removing them to clean is up to you. The fans are also required to be removed if working on some other components in this device. The fans in this device are 7 x 7 CM.

Qué necesitas

  1. Razer Blade RZ09-0102 Fan Replacement, Rear Panel: paso 1, imagen 1 de 1

    • Before you begin, be sure to turn off your laptop.

    • Using a Torx T5 screwdriver, remove the ten 1/8 inch screws securing the back cover.

    • Remove the back cover.

    Editar

  2. Razer Blade RZ09-0102 Fan Replacement, Fan: paso 2, imagen 1 de 1

    • Remove the three black rubber pads that cover the screws holding the fan.

    Editar

  4. Razer Blade RZ09-0102 Fan Replacement: paso 3, imagen 1 de 1

    • Use the Phillips #0 screwdriver to remove the three 1/4 inch screws.

    Editar

  5. Razer Blade RZ09-0102 Fan Replacement: paso 4, imagen 1 de 1

    • Disconnect the wire that goes from the fan into the white connector, but leave the wire attached to the fan.

    Editar

  6. Razer Blade RZ09-0102 Fan Replacement: paso 5, imagen 1 de 2 Razer Blade RZ09-0102 Fan Replacement: paso 5, imagen 2 de 2

    • Lift the fan out with your hands.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 6

Todo El Tiempo: 6,558