Saltar al contenido principal

Introducción

This guide will show you how to replace the wire harness in the Razer BlackWidow Chroma keyboard.

Partes

No se especificaron partes.

  1. Turn the keyboard over so that it is lying flat on its face. Use the iFixit opening tool to pry the rubber feet off the keyboard.
    • Turn the keyboard over so that it is lying flat on its face.

    • Use the iFixit opening tool to pry the rubber feet off the keyboard.

  2. Use a Phillips #1 screwdriver to remove the six screws on the back of the keyboard. Use an opening tool as a wedge between the front and back panel to pry open the front panel.
    • Use a Phillips #1 screwdriver to remove the six screws on the back of the keyboard.

    • Use an opening tool as a wedge between the front and back panel to pry open the front panel.

    • If the front and back panel won't separate, DO NOT use excessive force. This may result in damaging the keyboard.

    • Instead, slide the opening tool across the keyboard in between the front and back panel. Go around the edges of the keyboard until the panels disconnect.

    • Flip the keyboard over so the keys are facing up.

    • Grabbing the left and right lips of the front panel, lift both ends up, removing the front panel.

  3. Using a Philips #1 screwdriver, remove all ten screws found on the edges of the keyboard.
    • Using a Philips #1 screwdriver, remove all ten screws found on the edges of the keyboard.

    • Two of the screws are found on either side of the main cable.

  4. Remove the wire harness. Remove the wire harness.
    • Remove the wire harness.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 22

Todo El Tiempo: 151