Saltar al contenido principal

Qué necesitas

  1. Razer BlackWidow Chroma Wire Harness Replacement, Rubber Feet: paso 1, imagen 1 de 2 Razer BlackWidow Chroma Wire Harness Replacement, Rubber Feet: paso 1, imagen 2 de 2
    • Turn the keyboard over so that it is lying flat on its face.

    • Use the iFixit opening tool to pry the rubber feet off the keyboard.

  2. Razer BlackWidow Chroma Wire Harness Replacement, Front Panel: paso 2, imagen 1 de 2 Razer BlackWidow Chroma Wire Harness Replacement, Front Panel: paso 2, imagen 2 de 2
    • Use a Phillips #1 screwdriver to remove the six screws on the back of the keyboard.

    • Use an opening tool as a wedge between the front and back panel to pry open the front panel.

    • If the front and back panel won't separate, DO NOT use excessive force. This may result in damaging the keyboard.

    • Instead, slide the opening tool across the keyboard in between the front and back panel. Go around the edges of the keyboard until the panels disconnect.

    • Flip the keyboard over so the keys are facing up.

    • Grabbing the left and right lips of the front panel, lift both ends up, removing the front panel.

  3. Razer BlackWidow Chroma Wire Harness Replacement, Wire Harness: paso 3, imagen 1 de 1
    • Using a Philips #1 screwdriver, remove all ten screws found on the edges of the keyboard.

    • Two of the screws are found on either side of the main cable.

  4. Razer BlackWidow Chroma Wire Harness Replacement: paso 4, imagen 1 de 2 Razer BlackWidow Chroma Wire Harness Replacement: paso 4, imagen 2 de 2
    • Remove the wire harness.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 7

Ultimos 7 días: 20

Ultimos 30 días: 65

Todo El Tiempo: 1,021