Introducción

Follow these steps to disassemble the drill and replace the planetary gear for the RIDGID R84015 X2 power drill.

Partes

No se requieren partes.

Remove the backplate.
  • Remove the backplate.

  • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

Agregar Comentario

Remove the drill handle.
  • Remove the drill handle.

  • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

Agregar Comentario

  • Remove the gear casing from the body.

  • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

Agregar Comentario

  • Prepare to remove the gear chamber.

  • Using the Phillips #2 screwdriver, unscrew the four screws at the rear of the plastic gear chamber.

Agregar Comentario

  • Remove the motor from the drill by gently pulling the motor away from the gear chamber.

  • NOTE: Handle the gear chamber with caution as the gears are now loose.

Agregar Comentario

  • Remove the plastic gear chamber.

  • Using the Phillips #2 screwdriver, remove the four screws that attach the plastic gear chamber.

Agregar Comentario

  • Remove each component from the gear assembly. Replace components as needed.

  • Reassemble the drill following the gear replacement instructions in reverse order.

Agregar Comentario

Linea de Meta

2 personas más completaron esta guía.

Evan Long

Miembro Desde 15/04/10

232 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 15-48, Garner Spring 2010 Miembro de Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Miembros

5 Guías creadas

Very helpful, thank you! I was not sure how to detach the motor from the gearbox and didn't want to apply any brute force, and this explained it well.

YURIY - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 27

Todo El Tiempo: 5,411