Introducción

Follow these steps to disassemble the plastic casing of the RIDGID R84015 X2 power drill.

  1. Remove the backplate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

    Agregar Comentario

  2. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

    Agregar Comentario

    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

    Agregar Comentario

    • With your drill taken apart, move your attention to the trigger and forward reverse switch.

    Agregar Comentario

    • Check to see that the forward reverse switch isn't broken.

    • NOTE: small tab on trigger fits into groove on forward reverse switch

    Agregar Comentario

    • With the battery attached, check that the wires work when the trigger is pulled.

    • Put multimeter wires here.

    • If wires work and drill doesn't, the problem is with the motor.

    Agregar Comentario

    • Make sure plastic is not broken and switch is not stuck.

    Agregar Comentario

    • Looks good, doesn't it?

    Agregar Comentario

Linea de Meta

2 personas más completaron esta guía.

Brian

Miembro Desde 12/04/10

97 Reputación

1 Guía escrita

Equipo

Cal Poly, Team 15-48, Garner Spring 2010 Miembro de Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Miembros

5 Guías creadas

I was able to diagnose and fix my problem with my black and decker following your instructions. TY

boxingchaos2011 - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 2

Últimos 7 Días: 14

Últimos 30 Días: 73

Todo El Tiempo: 10,157